This list contains only the countries for which job offers have been published in the selected language (e.g., in the French version, only job offers written in French are displayed, and in the English version, only those in English).
As a Manufacturing Technician – Paint/Burn‑Off, you will support manufacturing operations by maintaining, troubleshooting, calibrating, and repairing production and metrology equipment to improve uptime and ensure quality and compliance. You will perform preventative and corrective maintenance, coordinate calibration activities, document results, assist with equipment validation and new product introductions, and collaborate with Engineering and Quality partners. You will also contribute to SOP development, lean manufacturing initiatives, and continuous improvement efforts while ensuring all work is performed in accordance with established procedures.
Job Responsibility:
Maintaining production equipment and performing general maintenance to increase production uptime
Providing a high level of problem-solving, diagnostic, and repair of plant equipment and equipment components
Using hand tools, reassembling instruments and replacing components
Communicating status of open issues
Serving as a technical resource on metrology issues and assisting with development and implementation of calibration procedures
Coordinating calibration and preventative maintenance activities and maintaining records
Working with calibration vendors for on-site and off-site calibrations, equipment repairs, and purchasing
Test equipment set-up and validations (IQs, OQs, PQs)
Participating in new product introduction, setting up new production areas
Collaborating with Engineering
Assisting in writing new or revised Standard Operating Procedures and Work Instructions
Participating in lean manufacturing activities and initiatives
Ensuring all tasks are performed in compliance with applicable Standard Operating Procedures
Requirements:
Associates degree in Engineering, Technology, Automotive, Electronics, or related technical subject area preferred and or 3 or more years of experience
Electrical and mechanical competence with a minimum of 2 years of hands-on experience repairing electromechanical systems
Medical Device or Pharma Manufacturing experience is preferred